DELETED

[DELETED]

DELETED

[instroke]

I have Instroke LE 3x7 (Python). 1 pipe for butt and 2 pipes for shafts are longer than all others. How to enlarge depth of pipes?

I am not sure what you want to do. We, Instroke, can remove some of the high denisty foam rubber at the bottom of the tubees to give you about .5 inch to 1 inch of more room if you like.

Just contact us at 1-888-806-0275 and ask for John Collins to discuss it.

John Collins
Instroke Sports LLC

[DELETED]

DELETED

[instroke]

Follow these directions carefully.

1. Very carefully remove the nails at the bottom of the case.
2. Very carefully remove the bottom. Mark the bottom so that you can put it back exactly like you took it out. This is so the nails will line up in the same holes.
3. Push the tubes out from the top of the case about 2 inches.
4. Cut a small X in the very bottom of the butt tubes that you want to remove the plugs from. DO NOT CUT THE LINER - STAY AWAY FROM THE BLACK LINER.
5. Using a house cue push the foam rubber out of the the tube.
6. Cut the foam rubber to the desired height. Leave at least .5cm of foam rubber to prevent the cue from taouching the wood on the bottom.
7. Replace foam rubber.
8. Using packing tape, replace the tape you cut.
9. Push the tubes back into the case. IF YOU PUSHED THEM OUT TOO FAR THEN YOU WILL NEED TO INSERT THEM FROM THE TOP.
10. Apply glue the bottom of the tubes and the wood piece.
11. Replace wood piece and nails.
12. Push tubes down from top so that they seat against the wood and let the glue dry.

That's it.

John

[DELETED]

DELETED