Dimension of the Ultimate Tip Tool?

[tgscordv6]

Can somebody give me the dimension of the Ultimate Tip Tool? I'm trying to order one, but it probably wouldn't be short enough fit my box case. I will need to order everything separately if it doesn't fit. Responses will be greatly appreciated.

[skor]

the ultimate tip tool is about 1x3.5 inches, and it sucks
it will scratch and chip your ferulle, the shapers are great but you can get just the a shaper.

[Kokopuffs]

I agree, I use it to shape the tip to either a nickel or dime radius but the burnishing legs succeed in scratching my ferrule quite well. In hopes of avoiding that problem, I plan to use a dremel tool to grind the inside-ends of the legs to a larger width and will cover them with electrical tape.

[skor]

you should get the Porper Tip Burnisher, it works great
if the tip is realy realy mashroomed you can cut the edges with a box-knife and then use the burnisher :)

[Kokopuffs]

Thanks for the recommendation. I'll get one.

[Tanar]

The Porper tip burnisher works well and if you want to shape or re-shape your tip, the Willard Nickle or Dime shaper will do the job very well.

[tgscordv6]

Thanks for the suggestions everyone. 8)